What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 03.07.2025 04:01

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
How could Trump, with his deplorable garbage supporters, manage to win an election?
(Dc diagram shown, AC is similar).
A circuit breaker is similar, but is resettable.
He then describes Rainy Season and Lightning.
Scientists issue urgent health warning to anyone who eats meat - UNILAD
One is “what exactly is in a ‘surge protector’ ? ”
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Because the load is inductive, the current lags the voltage.(by a bit).
At one ohm, the resistor has a maximum of 1 watt power.
Here is a simplified AC power diagram.
Upvotes:
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
but this device (an Inductor) … impedes the rapid changes in the current.
Why is Hinduism not polytheistic?
The other is “what does a “fuse” do?”
[image of Common-mode choke]
nine
[old diagram got deleted by accident]
The third is lightning and “how it gets conducted into a home.”
But it can get overloaded, and no longer works.
Dakota Johnson Uses Tissue to Cover Cleavage Amid Wardrobe Malfunction - Yahoo
a photo is worth a thousand words.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Xiaomi confirms imminent launch of new flagship phones and tablets - Notebookcheck
The bolt then partially travels down the line to your home.
but I think this circuit , shows a few more pieces.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
There are three different concepts here that are getting confused.
The MOV will conduct when the voltage exceeds 50% of line voltage.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
He then describes the function of a fuse.
I post the exact comment here.
One
So, the voltage could go up to 500 volts, and the fuse will not open up.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
An AC voltage/ current source, and an ac inductive load.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–10–10[John johnson John Johnson ]
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
so, what happens?
It seems Mohan does not understand the difference between a comment and an Answer.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
the problem then depends on "how fast does the fuse operate?".
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
2024–10–16 [ OO OLAOYE OYEBODE ]
For this case there are devices called Metal oxide varistors (MOV).
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
It also is a device that limits the change in current flow.
This is 'the assistant's answer'
This one hit behind the barn.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is where the MOV conducts again, and dissipated the energy.
Edit 2024–10.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
There are two important concepts here.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
A fuse is a non-resetable over current circuit protector.
Barnstars:
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
What is lightning?
But… the neutral is now “floating” because of the 1 ohm resistance.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
What does a fuse do?
This device then solves the entire problem.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
eight
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
At least they know the answer if they wanted it.
what exactly is a ‘surge’ protector?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
First Sentence:
In schematic diagrams this is the symbol for a fuse:
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–14 [Omar Gharbi Omar Gharbi ]
These are simplified answers to the original question, and does not change anything I wrote above.
He then asserts :
These devices are installed between the “hot” and “neutral” and protective ground.